Three separate sensors in one 4" tube. Up to 16 of these can be attached to any Goose monitor. Perfect for use with the MiniGoose. Use a splitter to expand the number of jacks. Ships with clamp-style mounting clip.

Connect up to 16 of these small combined sensor units to get complete climate monitoring in hard to reach places. Put one next to a fan and be alerted the minute it stops.

Up to 16 temperature probes can be placed in hot spots. Stick one in the cabinet inlet and one in the outlet to diagnose air-flow problems. Put one in the A/C vent to detect problems at the source. Accurate to +/-0.5°C. Run them hundreds of feet from the Weather Duck, WeatherGoose or MiniGoose.

Converts an analog sensor into a digital sensor that can be connected to a 1-wire port. Useful for units that don't have an I/O port(like the MiniGoose) or for adding additional analog sensors to a unit that does. The CCAT needs to be programmed for the type of analog sensor that will be connected to it. When ordering select please choose one of the following types: water, door contact, current transformer, or millivolt

For multiple remote sensors this 5 port splitter makes the installation easy. Chain them together to connect up to 16 sensors. One RJ-11 plug, five receptacles, 5 foot cord. White.

Put this cable around the periphery of your server room or around data cabinets and get early warning of water entry. Get an e-mail or page when water hits. Comes with wall mounted control box. Uses two Weather or SuperGoose I/O ports. Reports when the cable is wet, disconnected or faulty.

This simple magnetic sensor detects when the cabinet door is open. Get an e-mail with a web-cam photo attached when the door opens and see who is messing with your gear.

Know when smoke invades your room. The kit contains a standard Kidde sensor plus all the wiring to connect to a WeatherGoose, SuperGoose or WeatherDuck. Up to 3 per Goose or Duck.

Detect rising water before it ruins your gear. Connects to the I/O ports on the WeatherDuck, WeatherGoose and SuperGoose.

Update existing power strips with this in-line power meter. By inserting the meter between the power source (typically a power strip) and the power source (wall plug or PDU) you can easily learn amps, volts, watts and power factor. The values are continually displayed in bright red LED numerals. The standard EGG0-IEC uses C13 and C14 connectors. A kit EGG0-NEMA adds two North American style connectors for 5-15 NEMA connectors. A cord and adaptor easily convert the unit to typical power strip connectors. Using these connectors the EGG0 is rated at 15 amps.

This is a sample of a current transformer that can be attached to a WeatherDuck, WeatherGoose or SuperGoose. This one measures 100amps, single-phase.

Plugs into a standard outlet. Alerts you when city power is lost, so you know how long the UPS has been on. Connects to the I/O port on the WeatherGoose, SuperGoose and WeatherDuck.

Designed to monitor -48 volt telephone batteries this sensor converts the positively grounded batteries into a negatively grounded 0 to 5 VDC signal capable of being monitored be any of the WeatherGoose Monitors. Connects to the I/O port on the WeatherGoose, SuperGoose and WeatherDuck. No separate power supply for this sensor is required.

Why run wires to your WeatherGoose? Put one of these boxes at each end of the Cat 5 cable and the power is supplied over the Ethernet cable. Maximum cable length 300 feet. Works with any Goose; Weather, Super, Mini 1 and 2.